DATEC - YOUR MOULDING MATERIAL OPTIMISATION PARTNER FOR SAND TREATMENT
datec is the only company in Europe that supports you in modernising your electronic equipment for sand treatment, from planning as a manufacturer to delivery, right through to the commissioning stage.
It is well known that moulding in casting plants is heavily dependent on the quality of the moulding sand and the demands of the components to be cast. Active moulding sand management to optimise moulding sand therefore ensures that used moulding materials (including used sand) can be reprocessed in parts and reused for new batches when mixed with fresh moulding sand. A prerequisite for this is that the sand has been previously inspected by sand inspection systems during sand treatment and has then been adequately enriched with moisture and binding materials. Using systematically arranged moisture measuring points throughout the sand circuit, with the help of our water dosing the moulding sand can be individually configured according to a formula in coolers or mixers and our binding material dosing. Thus, waste resulting from casting errors involving moulding sand can be systematically reduced in the long term.
In addition to moulding sand optimisation we will keep your sand treatment control system modules updated so that you have maximum protection against technical errors which could lead to plant downtime. Not only will you benefit from increased functional reliability of the individual assembly units, you will also be able to unlock additional potential as a result of the control system. Our control systems include components such as an energy management system, a detailed fault analysis, and an inspection control system. This in turn can further increase the cost-effectiveness of your plant.